Skip
Free domestic shipping over 15,000 yen | FREE DHL SHIPPING WORLDWIDE FOR ORDERS 50K+ yen : Details
Free domestic shipping over 15,000 yen | FREE DHL SHIPPING WORLDWIDE FOR ORDERS 50K+ yen : Details
Erica Synths Black Stereo Delay2

Erica Synths Black Stereo Delay2

Erica Synths
¥51,900 (Tax excluded ¥47,182)
Hi-Fi stereo delay with custom DSP engine
Delay/Chorus/Flanger

Format: Eurorack
Width: 12HP
Depth: 35mm
Current: 120mA @ + 12V, 39mA @ -12V

Manual PDF (English)

In stock. Orders made by 15:XNUMX will be shipped the same day

MUSICAL FEATURES

Black Stereo Delay2 is a high-fidelity stereo delay with many unique features based on a custom DSP engine.tape, BBD, digital delayThree types of emulation are provided and can be toggled with a switch on the left. The operating mode of the delay tap is set by the switch on the right.stereo, crossfeed, ping pongYou can choose from. With control over delay time, feedback, tone, and stereo spread, you can design the most subtle effects. The set parameters arepresetIt can be saved asPresets are controlled by CVIt is also possible.

Feature:

  • Tape, BBD, digital delay type
  • Each type of tap operation can be switched between three modes
  • Delay time can be set with tap tempo and external clock synchronization (when clock synchronized, divide or multiply with Time)
  • 10 preset patches
  • CV controls for delay time, feedback, tone and preset selection
  • Adjustable Stereo Delay Spread This module works with the new Erika Shins DSP hardware and the effects were developed in collaboration with 112dB, a Dutch company known for its beautiful sounding effects.

How To Use

Interface

 

The explanation of each part is displayed by mouse over
About presets
Select presets 1-10 by holding Shift and turning Time. Hold Shift and press and hold TAP to save a preset, or press and quickly release TAP to recall a preset. Saved presets can be controlled by CV from the "Patch" jack

firmware Update

The steps to update the firmware for the Black Stereo Delay2 module are as follows:

  1. Download the audio file to your computer
  2. Turn off your Eurorack system and connect the audio output (headphone output or audio output from your sound card) to the L(MONO) IN of the Black Stereo Delay2 module. Set the TYPE switch to position D (lowest)
  3. Turn on the Eurorack system while holding down the SHIFT and TAP buttons at the same time. The five LEDs on the right side will start blinking, indicating that firmware update mode is active
  4. In this state, play the audio file from your computer. Five LEDs on the left indicate the audio level of the firmware file being input. At least 5 LEDs must be lit for sufficient audio level. If less than 3 LEDs are lit, switch the TYPE switch to position B to increase the audio level of the input signal
  5. The firmware update will take a few minutes. During a firmware update, a flashing TAP button indicates that the update is progressing normally, and a flashing SHIFT button indicates an error. If an error occurs, retry the update from step 1
  6. Reboot the rack once the update is complete
Top
x