Trogotronic m277

Please be sure to read the notes regarding the power supply below.

m277 is a high gainVacuum tubeIt is a dual VCA that adds a character with a strong sound using.In addition to the normal volume, it has 2 channels of VCA that can control the amount of overdrive with the knob and CV by "Drive".

Also, by PAN controlPanningIn addition to acting as a panner that controls the knob and CV,Drive amount panningCan also be controlled (Pan Drive) with another knob / CV.

It has the following features.
 

• --Two tubes VCA
• --CV with one attenuator for each channel
• --With one Drive CV for each channel
• --Panning control is possible with CV and knob (only one of pan and individual VCA CV can be used)
• —— Panning drive control with CV and knob is possible
• --ExternalLine level signal can also be boostedGain design with plenty of room
• --The CV range is 0-5V
• --Addition of warm overtones by vacuum tube
• ――The four lamps display the gain and drive status.
• --Uses a high-performance Slovak vacuum tube
• --Requires regular Eurorack power supply
• --The included AC adapter can be used as an auxiliary

 

About auxiliary AC adapter

Since the m277 uses a vacuum tube, it draws a very large amount of current and starts from the power supply.700mAIt draws in the current.Auxiliary AC adapterBy using, this current consumption can be reduced and the power supply on the modular side can be kept stable. If you do not use the AC adapter together, pay close attention to the current capacity of your Eurorack power supply. The AC adapter (12VDC) that can be used in Japan is included.

Please note the following points when using the auxiliary AC adapter.

• -Only 12V is supplied from the AC adapter, and power is always supplied from the Eurorack power supply to -12V and 5V.
• ・ Power supply from the AC adapterBe sure to turn on the power from the railOr start at the same time.
• ・ When disconnecting the AC adapterBe sure to turn on the power from the railPlease remove the adapter.