Tiptop Audio Z-DSP Card Clocked Delays

Z-DSPClock delay DSP card for. Z-DSP is required for use.

For any algorithm, input the master clock for synchronization to the middle jack (VC-P3 jack) of the three CV inputs on the Z-DSP. Also, set the corresponding knob (VC-DSP2) to the 2 position. The clock input for synchronization does not respond correctly with a short trigger signal. Please set the gate length of the clock to 0% -25%.

The clock speed that can be used depends on the BPM of the input clock:

• BPM 60 or less: Input a clock of 8 minutes or 16 minutes with a pulse width of 50%
• BPM61-120 ・ ・ ・ Input 4 minutes clock with pulse width 25% -50%
• BPM120-180 ・ ・ ・ Input a clock of 4 minutes or 2 minutes with a pulse width of 25%
• BPM 180 or higher: Input a 2-minute or whole note clock with a pulse width of 25%

The algorithm is as follows.

• 1. Mono L / R Clocked Taps
• 2. Mono Clocked Low Pass
• 3. Mono Clocked Fdbk + HPF
• 4. Mono Clocked Bandpass
• 5.Dual Clocked Delays
• 6.Clocked Ping Pong
• 7.Dual Clocked HPF
• 8.Dual Clocked Feedback