Soundmachines LS1 Lightstrip

For this product, insert the ribbon cable into the module so that the red stripe is on top.Please note that the labels on the sticker are a little difficult to understand.

MUSICAL FEATURES

The LS1 is a controller module that outputs gates and CV signals by pushing and moving the surface with your finger. You can also record movements, with a sampling time interval of 15ms. The output CV is in the range of 0-5V, but it can be switched to 0-10V by the jumper on the back.

Touch the white slider to output the gate signal from the Gate output, and continue until you release your finger.From the CV outputIt outputs a voltage that reflects the position of your finger. If you touch the slider after pressing the rec / mode button to turn on the LED, the position will change even if you release your finger from the slider.ホ ー ル ドWill be

With your finger on the slider, press and hold the rec / mode button.Recording modeEnter the rec / mode button and record the slider movement for up to 8 seconds. Release the button to end recording. Also, by setting the jumper on the back, change the gate output to the gate input,Recording with gate signalThere is also a bonus mode.

The default orientation is such that the jack is in front (down). In order to keep the upper and lower sides of the slider display and the upper and lower sides of the output voltage the same even when installed upside down, short the "Board" jumper on the back.

DEMO