Skip
Free domestic shipping over 15,000 yen | FREE DHL SHIPPING WORLDWIDE FOR ORDERS 30K+ yen: Details
Free domestic shipping over 15,000 yen | FREE DHL SHIPPING WORLDWIDE FOR ORDERS 30K+ yen: Details
Intellijel Designs uMIDI 1U

Intellijel Designs uMIDI 1U

Intellijel Designs
¥ 17,800 (Tax excluded / tax excl)
1U version of uMIDI
1U (Intellijel) MIDI Converter

Format: 1U (Power supply is shared with Eurorack 3U)
Width: 22HP
Depth: 25mm
Current: 47mA @ + 12V, 3mA @ -12V

For the latest Intellijel manuals and firmwareManufacturer support pageSee also

Intellijel's 1U module is not compatible with the 1U "TILE" format from Synthrotek or Pulp Logic. Please install it in Intellijel's 4U, 7U case, etc. For Intellijel 1U size specificationshereto see the available categories of products and services.

* This 1U module requires a separate MIDI jack part. The Intellijel 7U Performance Case and 4U Palette Case have a MIDI jack on the top of the case, so no additional products are required, but if you are using another case such as Intellijel's old 4U caseuMIDI Jacks 1UWill also be needed.

MUSICAL FEATURES

uMIDI is a MIDI-to-analog signal conversion module that provides the functions required to synchronize and control the modular from computers, iOS devices, and MIDI hardware. There is no need for menu operations, etc., and it can be easily used with two buttons.

The left section provides outputs related to clock and transport. One of the clock outputs can be output as 1/1 and the other can be set by the number of divisions. The Run and Reset outputs are used by patching the corresponding inputs of the sequencer.

The right section is equipped with one set of outputs required to control a single voice via MIDI.

Just plug in a MIDI cable or a USB cable, set the MIDI channel to LEARN, and play. If you press the LEARN button and then send a MIDI note, uMIDI will convert and output the MIDI note of that channel. By pressing and holding the LEARN button, the current MIDI channel and clock division number will be stored, and the settings will be recalled automatically even when restarted.
 
  • High-speed ARM processor with low latency
  • MIDI input via DIN or USB
  • Two clock outputs, one clock divider
  • Supports bend and portamento and can accurately output pitch signals of 0-10V
  • Gate and trigger signals can be output separately
  • Modulation wheel and CC output allow further modulation
  • Firmware can be updated via USB
As a spec of 3UuMIDIIs equivalent to For the function of each jack and button, refer to that product page.
 

firmware Update

Follow the steps below to update the firmware.
  1. Power down the module and disconnect all connected cables
  2. Connect the USB cable from the back of the module to your computer.
  3. IntellijelページOpen the updater downloaded from and select the module and version from the dropdowns.
  4. LEARNHold down the button and power cycle the module.
  5. At the bottom of the updaterUpdateWhen the button is pressed, the progress bar starts, and when the message “Update completed successfully” is displayed at the end, the update is complete.
  6. Restart the modular and it should work with the new firmware
x