uMIDI is a MIDI-to-analog signal conversion module that provides the functions required to synchronize and control the modular from computers, iOS devices, and MIDI hardware. There is no need for menu operations, etc., and it can be easily used with two buttons.

The upper section provides clock-related outputs, one for 1/1 and the second for the number of divisions. The Run and Reset outputs are used by patching the corresponding inputs of the sequencer.

The lower section is equipped with one set of outputs needed to control a single voice via MIDI.

Just plug in a MIDI cable or a USB cable, set the MIDI channel to LEARN, and play. If you press the LEARN button and then send a MIDI note, uMIDI will convert and output the MIDI note of that channel. By pressing and holding the LEARN button, the current MIDI channel and clock division number will be stored, and the settings will be recalled automatically even when restarted.
 

• High-speed ARM processor with low latency
• MIDI input via DIN or USB
• Two clock outputs, one clock divider
• Supports bend and portamento and can accurately output pitch signals of 0-10V
• Gate and trigger signals can be output separately
• Modulation wheel and CC output allow further modulation
• Firmware can be updated via USB

firmware Update

Follow the steps below to update the firmware.

1. Power down the module and disconnect all connected cables
2. Connect the USB cable from the back of the module to your computer.
3. IntellijelPagesOpen the updater downloaded from and select the module and version from the dropdowns.
4. LEARNHold down the button and power cycle the module.
5. At the bottom of the updaterUpdateWhen the button is pressed, the progress bar starts, and when the message “Update completed successfully” is displayed at the end, the update is complete.
6. Restart the modular and it should work with the new firmware