Industrial Music Electronics Zorlon Cannon MKII (Model 1986-2)
Current: mA @ + 12V, mA @ -12V
Manual pdf (English) <
A external clock input.When there is an input, the internal clock is released and synchronized with the external clock.
It is a signal output that mixes the four outputs belonging to the A clock through the Atte inverter.
Each output has an attenuator, allowing you to adjust the amount sent to MIX OUT.By setting it in the center, the amount sent to MIX OUT is 0V, it is added clockwise and subtracted counterclockwise.
Individual outputs of four LFSRs powered by the A clock.
Control of A's internal clock.It can be controlled by a CV with a knob and an Atte inverter.The button switches the clock range, and red = low / orange = normal / green = double.In double mode, it responds to both ON timing (rise) and OFF timing (fall) of the external clock.
Indicates whether the LENGTH / TAP encoder is setting LENGTH or TAP for the selected LFSR.
Displays the LENGTH and TAP positions of the selected LFSR.
Set the LENGTH / TAP setting by turning the encoder while pressing the Output Select button. Switch the LFSR to be edited.
You can also save the current LENGTH / TAP settings by pressing and holding the encoder for 2 seconds.Press the encoder twice quickly to load the settings.
The output is bipolar, but otherwise it is similar to CH A.
It is a SEED input that can reset the SEED that points to the initial value of the data by sending a gate. It works on all eight LFSRs.