Skip
Free domestic shipping over 15,000 yen | FREE DHL SHIPPING WORLDWIDE FOR ORDERS 50K+ yen : Details
Free domestic shipping over 15,000 yen | FREE DHL SHIPPING WORLDWIDE FOR ORDERS 50K+ yen : Details

Erica Synths Pico Drums

End of production
Drum module with 2 sample sounds and powerful parameter settings!

Format: Eurorack
Width: 3HP
Depth: 35mm
Current: 35mA @ + 12V, 15mA @ -12V
Japanese manual
English Manual Page (pdf)

MUSICAL FEATURES

Japanese manual

Pico DRUMS is a 12-bit drum module that can play two samples. 64 samples are stored,Drum ProgrammerIt is also possible to replace the sample inside by using.

Features and usage:
  • Plays two independent drum sounds
  • The drum sound can be selected from 64 samples. Select the channel you want to change the sample with the switch, push the encoder to make it not illuminate, and rotate it to switch the sample. Selected sample is indicated by LED combination
  • Pitch, decay and volume can be set for each channel. Select the channel you want to set with the switch and push the encoder to change the color. You can set the pitch for green, decay for red, and volume for yellow (orange).
  • Drum ProgrammerYou can upload your own sample at
  • Each channel can be triggered individually
  • Drum sounds of two channels are mixed and output
  • If you set the "EXCL" switch, it will be in a mode so that the drums of two channels do not sound at the same time (this is a choke setting that is often used in hi-hats etc.).
  • Playback is done at 12 bit / 44.1kHz, giving you a fat drum sound
  • For CV input, CH1 samplePitch / decay / volume / sample selectionCV control of any of these is possible.
    Set the switch to CH1 and press and hold the encoder for 2 seconds. Then turn the encoder and the color will change, so select the parameter you want to CV control. Green is pitch, red is decay, and yellow (orange) is volume. When there are no colors and six LEDs are lit, sample selection. After selecting the parameter you want to control, push the encoder to confirm.
    When controlling sample selection by CV, the sample changes every semitone unit at 1V / Oct, so accurate sample selection can be performed by using a CV that has passed through a quantizer, etc.
  • Up to 6 selected samples and parameter settingsSave and loadIs possible.
    Set the switch to CH2 and press and hold the encoder for 2 seconds. The encoder will turn green and the position of the glowing LED will change as you turn it, so when you select and push the setting you want to load, that setting will be recalled. If you do not select load and turn the encoder further, it lights in red. At this time, the save destination will be selected. Select from six save destinations indicated by the LED position and push the encoder to confirm the save.
 
Top
x