
Befaco Mex
Format: Eurorack
Width: 4HP
Depth: 20mm
Current: 30mA @ + 12V, 10mA @ -12V
Format: Eurorack
Width: 4HP
Depth: 20mm
Current: 30mA @ + 12V, 10mA @ -12V
Befaco Noise Mex is an expander module that adds an 8-step gate sequencer to Muxlicer. Adding a new gate output line to the Muxlicer sequence This unit is equipped with a 3-position switch for each step, so that the Muxlicer itself can generate the same number of gates, or the output can be set individually. is.In addition, Mex supports daisy chains, allowing you to expand the output line as many times as you need.
Refer to the image below and connect the EXPANTION_PORT on the back of the Muxlicer to the TO_MUX port on the Mex, paying attention to the direction of the cable.The warranty does not cover the failure of the module due to incorrect connection.Make sure to connect securely while checking the mark on the board.Use the THRU port to connect multiple Mex.In this case as well, pay close attention to the orientation of the cable.
Mex is connected to Muxlicer's internal clock. Mex's gate sequence follows the same steps generated by Muxlicer, but Mex allows you to select a mode for each step, allowing you to create different versions of the original sequence.
In addition, Mex's Gate In can act like a comparator internally, so you can get interesting results by inputting signals other than the gate.Below is an example of inputting an analog sine wave into Gate In, and the result is a gate with a length equal to half the period of the sine wave.